Search:

Loaded up 50 5.56 rounds with 62 grain PSP for some pigs.

I have used a hair dryer and got it flowing when I used it. I now powder coat my cast.

Well indeed! Sometimes things like this is what makes kids go good instead of bad. More of this needs to be done in our whole society.

Don't overlook IMR4227. I have ran as high as a 245 grain bullet with full function in an carbine length AR. should be 9.5 grain.

30 grain v-max should be perfect for coon...

This I do also and it's worked well for me.

Ditto, I have the same mold and have been pleased with the accuracy. I would recommend anyone who owns a .380.

I have one and as close as I can measure with a Micrometer it is .309. Not all runs of these guns will measure the same as manufacturing tolerances will ever be the same. I have gotten excellent...

19 grains of h-335 in my ar15 carbine will cycle and shoots acceptably for me. This is with the lee 55 grain mold. As usual start low and see if it works with your ar.

Beautiful deer and proof you don't need a magnum to take a whitetail!

I have loaded some 311041 which with powder coat and gas check weight was 185. Used Trail Boss for ~1050 FPS. These worked well in my AR in 7.62x39. I believe that if your rifle will use a .308...

Good deal. He would have to go. Non poisonous would get a pass.

Worked in a refinery for years and this is spot on...

I would tentatively say yes as I can't look at the powder. Our ancestors when on an extended hunt would sometimes get their powder wet and have to do as you suggested, "let the sun dry it out". ...

I think they need to 'Barney Fife' this one and nip it in the bud...

This is correct. That is until this administration can figure a way to screw this up...

Glad to hear that you are on the mend. I am interested in your wares once you can produce.

Ditto, these are my findings too. I cast ~12-15 BHN on rifle rounds powder coated up to ~2200 FPS. I have had no leading issues and get hunting accuracy.

Why worry? I have and use both. Isn't America still great in some regards!

Good deal Mr. Gibson and thank you for the info!

I size 38/357 to .3575 with a lee push through sizer. Bullet is powder coated and several I use are 105 to 200 grain. I have had no issues with leading.

I am 71 and still deer hunt with a single shot most times. The times I take a MSR is coyotes and hogs where multiples shots are possible. I too use a 357 Max and it leaves nothing wanted 200 yds...

Use the one that you shoot best with the loads you have. Make sure you have a good skinning knife and drag rope with you or a two wheel cart handy as you will need it. I highly doubt you will...

Tungsten sizing ring. Permanent. Negates the use of lube. I still make sure the brass is clean before using.

Update; Slight flash rusting on the metal so will treat as corrosive and use for range sessions. Thanks for the reply's!