Search:

Instant Read Meat Thermometer Deep Fry Thermometer Oven Thermometer with Dial Thermometer（10-290℃/50-550℉） for Turkey BBQ Grill Oil by AikTryee. $7.97 on Amazon. Drill a hole thru top of your...

Anyone load buckshot with Unique powder? I'm not interested in high velocity hunting loads, just some low recoil 12 ga loads that I can have fun with at the local gun club range. I've seen YouTube...

Those bullets already have a lube on the OD, so are ready to load and shoot. Taurus bullets used to be Alberts bullets, and they used a dry powder lube on the OD. You can see the lube on the...

Best place I've found is to visit scrap metal yards and ask for "hard lead". They can test the lead with a hand held device to determine its composition. They usually charge less for hard lead, as...

The easiest way I've found is to spread them on a cookie sheet lined with paper towels, and bake in the oven at lowest setting (170 F) in my oven. I double up on the paper towels. Remove them from...

I didn't see this thread for BCB Bullet Coat from South Africa when I started a new thread today. There is very little information on YouTube or online forums, but what I've found seems to indicate...

Has anyone tried BCB Bullet Coat from South Africa? There is very little information on YouTube or online forums, but what I've found seems to indicate that it's easier to apply than Hi-Tec, has...

Columbia Coatings offers Clearance powders with many listed at $5.00/lb. Has anyone tried powder from this company for the shake/bake method of coating bullets and if so, how did it perform? ...

If you want to harden them, drop the powder coated bullets into water when you take them out of the oven when powder coating. It works very well, and there is really no need to drop them into water...

Lay several layers of paper towels onto a cookie sheet, spread your bullets onto the paper towels and bake for 5 minutes in a heated oven set to the lowest setting (my oven is set at 170 deg F, but...

Payment sent.

One 8 cavity no lube grooves for powder coating please.
Would also be interested in similar design for 200 or 230 grain 45 ACP mold.

Don't know how to mask my email address so sent PM with my...

I'm interested in one.

Appreciate the response.

I've accumulated a few rejects along my learning curve with powder coating lead cast bullets. Has anyone salvaged the lead from coated bullets by remelting them, and if so, what were your results? ...

How well does it work for the shake-n-bake process without BBs? Any pictures to share?

My email address sent via PM to MiHec

I see your point Derek and mozeppa, and may have to rethink my process!!

Thanks for the explanation Derek. I was just curious. I'm looking more for consistency in results, and not necessarily for a reduced time. I agree that the time savings is probably not that much. ...

Has anyone experimented with a reduced bake time and where did the 20 minute "rule" come from? I use the shake and bake method using HF red powder, with a toaster oven at 400 F confirmed with a...

I'll take one 130gr without lube groves with BB.

I'd be interested in the 75gr 45 2.1 design if the price is reasonable.

I have recently moved into the area and need a place to shoot. The Langhorne Rod and Gun Club (in PA) is about 10 minute drive from where I live. I'd like to join the club but in talking to the...