Search:

put a under primer wad under the pistol primers, it will save your breach face. Or use Fed210 primers and not worry about it

pedersoli sharps. 45-100, .450/.458/.460. DDPP cast from 16+1lb of 95-5. fed210m, .060 poly wad, bullet seated .086 in case, 108.5gr Swiss 1.5f

I would like to see a 1-18 twist... the 1-20 should be fine if your sticking to shorter bullets. not sure of your intentions with the rifle.

dont use a bore dia bullet with smokeless. your just asking for trouble. it wont bump up like it does with black. A groove dia bullet will work just fine though with smokeless powder

Lyman makes the mini postell, it comes in at 330gr range depending on alloy. You can always have one made to your specs at one of the many mold makers. maybe take that design and have them shorten...

I dont think there is a "better" design but, you do run the chance of getting leading with a GG bullet after she gets really hot and only blowtubing, and or your lube fails because its ment for the...

whats the purpose of the rifle?? if its long range, doing anything at 100yd wont be worth your time anyway. get a good 200yd load and dial her up!!

40-82 crossno or 44-100

bore dia and smokeless isnt the best combo as it wont bump up very well. When you use BP dont resize your brass just add enough taper crimp to hold the bullet from falling out. You should be able...

Thats a fantastic looking rifle! what is the twist?? 1-18? I have a couple 44 cal molds and am having a 44-70 being built. one is a .443 DDPP mold and the other is a 3 reduced band GG bullet

This...

It really isnt about the weight, its about the length. If your twist cant support the length it will never be accurate at distance. I would find your twist rate out and plug that into a ballistic...

you will have a difference in case capacity, so your compression will change. I would adjust your load so compression was the same in both and start there. the target will tell you if speeds are...

It would be just fine at long distance.......if your can get a bullet that is long for caliber, problem is, not having the twist to support the length. I would try the 240gr's and see what happens. ...

I talked with Winchester and their reply was....(for my model) 86 were made. Mine is very new, as in last fall. I was told they were made for the 2016 Shot Show. I believe there is a 32-40 (ser...

285362

Ok this is going to sound weird but, my box and rifle say 00033. It too is a traditional hunter in 38-55.