Search:

I'm a long time lurker and occasional poster. I finally bought in as a member. I want to begin casting (primarily) boolits for swedish mausers, and I also want to powder coat them. So far I have a...

I'm also looking for 6.5 mm moulds in about the same weight range, but preferably without gas check capability. I don't yet have enough points to post my own thread yet, though. So I'm tagging on...

Best dog we ever had was half yellow lab and half malemute. In his prime, he was 115 pounds. Kindhearted, ears stuck out sideways, gently protective, and his tail should have been registered as a...

A few things I have done, you can judge the shame I feel.

Downloaded a Klingon phrasebook from the Internet. Answered the phone using it and tried to keep the conversation going for a while.
...

Thank you, Miss Ficklin, for teaching me to read using phonics. Back when Eisenhower was president.

Thank you for this. I may need it in the near future.

A 10% powder reduction also works.

IMR discontinued PB a while back, which greatly saddens me. I used it to good effect with 158 gr LRN in .38 spcl target loads when my wife was competing. Does anyone still use stocks on hand? As...

For sure!

I wonder . . . Will it work as a penetrating oil for rusted bolts? Those that even Kroil didn't help.

I found a surprising amount of lead boolit information in the Lyman 47th Edition So much that I've referred to it so often that it came apart and is now in a 3 ring binder.
(I'm a newbie here to...

I'm a new, wanna-be boolit caster. I've been a lurking member for a while, and try to read all that I can before I get into something new. I'm not new to reloading, which I began in 1994.

I...

I worked for a while at a non-chain tire store when I was in college in the 1970s. The owner was a cheapskate, and I quit when he instructed me to install tube-type tires on a 240-Z but without the...