Search:

I have had nothing but good experiences with Al and NOE. Maybe it would be a good idea to go back to bed, sleep a while and then get up on the other side of the bed. That makes the world look a lot...

If you want to stay close to Denver, take a look at the Scottsbluff/Gehring area. Eastern Wyoming has some good areas too.

I prefer Silhouette for my 9MM loads.

Yes, I do!

Thanks for posting this. It provides a lot of reasons to be thankful.

There is nothing wrong with your thinking. Some of us older folks remember when we were thankful to have a job. If the younger people don't appreciate the raise, they can always go somewhere else.

Others opinions will vary, but I always size and trim new brass before loading. You may never need to trim again.

Prayed for the surgery, those performing it and your future.

Here's another vote for a Lee 20# bottom pour. I've been using one for the last 10 years. My advice is to skip the Lee bullet sizing dies and go directly to the NOE system. It's a little more...

Closed

WTS - 9MM Brass – Ready to Reload

9MM Range Brass that has been inspected, decapped, sized and cleaned in a wet tumbler. It was finished with automotive wash & wax. 500 count plus an extra 10...

As long as the boolit is pure lead it should work fine. Make sure the bore is clean. Lube the barrel and the boolit. Then use a Plastic tipped hammer to drive the boolit into the barrel. Use a...

You should be able to size the .379 down to .377 without any trouble. I use NOE's sizing kit and bushings.

I had some similar experiences with a couple of Springfield Armory 1911's. The first thing I did was to sort my range pickup brass by headstamp. The second thing was to sell my case gauge, remove...

This is a link to the NOE .453 plug.

https://noebulletmolds.com/site/shop/bullet-casting-reloading/expanders/expander-plug-pistol/453-x-449-p-exp-plug/

Frankford Arsenal makes a wet media separator that removes the pins from the brass in about a minute.

The thermocouple came from Auber Instruments. I really like the stand. I wouldn't want to be without it.

I drilled a hole in the center of my pot lid and used a brass compression fitting to hold the thermocouple about a half inch above the bottom. This my original Lee pot with a My2ndRight stand....

NOE makes a 180 grain WFN. It feeds well in mine.

I am guessing that you are using white beadboard, sometimes referred to as Styrofoam. If that is true, don't use construction adhesive. Locktite PL 300 is the proper adhesive. It comes in large...

Most people recommend .001" over the bullet diameter. I have found that .002" over the bullet diameter works best for my 9MM, .357 and 45 ACP rounds. Since they don't cost much, I would purchase...

It's a USPS Small Flat Rate Box for Priority Mail.

You can order a custom seater plug from Lee for about $18 shipped. Look on their website.

Bump To The Top.

1 – Redding .357/.38 Special Micro-Adjustable Profile Crimp Die – Used, but like new - $43.00

1 – Lee Carbide 45 ACP Sizing Die – New - $13.00

1 – Lee 45 ACP Seating Die – New - $8.00

1 –...

Doug,

Thanks for the update. I'll be glad to wait for your 9MM service.