Search:

Please add me for 4 cav hp pb.
Thanks,
Fred
toroonefivefivefourat attdotcom

Hello,
I am not sure if this is the right place ask this question. Many years ago when I bought my first stars I got what I am describing as primer magazines with it.
I have two, a large and a...

SciFiJim,
Thanks for the reply. GH was supposed to GC. OOPS
How long do I have to get the money together?
Thanks for the help.
Fred

Hello,
I am fairly new to this forum. How much would a 4 cavity 2 hollow point with GH mold cost?
I am going to start loading for a 300 Whisper soon and think this would work for it. Any advice...

Thanks for posting these pages. Since Pressman and yourself had both, kindly, sent me the pages, I had not realized that you also posted here.
I need to buy jackets and lead to try them out....

Thank you ETG for the help.
Fred

Since I am copying the one Cris made, the plug will hold the bushing in the 7/8 body. I will get the bushing today or tomorrow along with the CS. How tall was your bushing? I ordered a 1/2" tall...

I am looking forward to finding out how hard they are.:groner: I bet it will be a learning experience, to put it lightly.[smilie=1:

Until I read your last post I thought that you had used a carbide CS not a burr. I had not looked in their catalog, but this is what I was thinking about-...

ETG,
I almost ordered 7/8 all thread, but I had the steel shaft here. I finished the knurling yesterday and will finish the cavity for the die after I have it in my hands to double check the...

I believe it was Cris that posted the instructions. I am following in both f your footsteps. I had a pump shaft that was about 1 1/4" that I turned down to 7/8" and threaded it to 14TPI most of the...

It's going to be the hard part for me too!!

Leadpot,
The body, if I remember right, can be in two positions. Vertical and the 45 you mentioned. Thanks for looking for me. I have not had a chance to do anything with it the last few days. I am...

I see what you are talking about. Thank you for the link and explanation. I did not understand you before. I will look at my press today and see if I can do that.
Regards,
Fred

Lead pot,
I obviously need to look at the machine to understand what we are talking about. Sorry about my confusion, but I will look into it. If I had to I might be able to cast something, but I am...

Lead pot,
I am not sure that I fully understood what you told me. I am a Noobie here. I need to shorten the center to center distance of the holes in the linkage. Would it be better to replace the...

Manleyjt,
Thanks for the reply and offer. I did send a message to Pressman as you suggested.
Regards,
Fred

Ken,
Thank you for the reply. I did not know that it had had been made for such a short time. I need to do some more reading here. It is a great forum.
Regards,
Fred

Hello,
I am new to this forum and perhaps I am posting in the wrong place. If so please move this.
I have an RCBS A3 press and would like to know if it would work well for swaging? After reading...

Hello,
Sent email with question.
Thanks,
Fred

Cris,
I am new to the forum and found your post very informative. Thanks for posting it.
Some of the pictures don't open up. I would love to see them.
Thanks again.
Regards,
Fred