Search:

Hitmiss>
I do not have natural gas at my place.

45-70 fan>
How big is the stove your daughter made for you? Most of the ones like that I have run across are pretty small. Does it get hot...

Take this for what it is worth. From what I read researching, the propane lasts longer and produces more heat. Keep in mind this is what I read on the net. Right now I am looking at wood stoves.

Thanks for the suggestion. They all make good sense. I was looking at the wood stoves last night an they are a definite option as I have ten acres of woods in my backyard. FYI to georgerkahn. Your...

Thanks for the responses. I was not planning on using the butane. I had in mind to get an adapter that ties in with the original propane gas line that comes with the stove. It allows a connection to...

As I posted earlier I am in the process of building a small time lead casting set up. As recommend by some I purchased a Lyman ten pound cast iron pot and a Lyman casting dipper. Now I am looking for...

Thanks for all the responses and ideas. I will probably pick up a Lyman or RCBS ladle when I start pulling stuff together. Thanks again

Thanks for the responses. I am thinking about to getting set up to make .690 roundball and various sizes of 12ga. buckshot on a small scale. I am just looking for ways to keep the cost down.

Can a stainless steel ladle be properly used to poor lead?

Deleted by OP. :oops:

My experience with Lee CS has been great. I purchased the Classic Turret Press Kit about a year ago and so far it has worked flawlessly. The look and feel of some of their accessories may seem flimsy...

I picked up a few thousand S&B SP primers at about 3:00 AM Saturday. Checked back for a friend at 8:00 PM and they were sold out of the SP primers.

In batches, I tumble, dry, deprime, run a Lee primer pocket tool in the primer pockets, run a dremel straight wire brush in the primer pockets then resize and prime. Sounds long and drawn out and a...

I purchased one from HF last summer and it came with 5 extra belts. I have not needed them though. I made sure the belt was adjusted correctly and lubed all the bearings. I also give it a little push...

I have not been able to find any of the powders listed by the OP. I have been using SR4756 for the past couple of months. It was all I could find at the time. Ordinarily I would use 231 but have not...

Greetings CB'ers

I am getting back into reloading after several years of abstinence. I am pretty much starting over from scratch. Other than a few SWC for 38 special I have not used cast boolits....