Search:

45 raptor uses 460 Rolland dies and load data. They can be made from 308 brass or bought new for a $1/shell. If you make them, anneal the 308 neck first or they may crack. I do it in 2 steps. A...

How many are you looking for? I have 500 brand new starline brass and a few used. PM me.

Listed elsewhere.

Sorry, on mids and misses this. I will respond in a few. Super8, I am in SC too.

I have a LAR Grizzly Mag for sale. Included is an extra magazine, spring, firing pin and a complete 45 acp kit. I put 5 shots through the barrel before it went into the safe and I have not shot it in...

PM sent.

I have drilled numerous snapped bolts but never one that small. I was thinking since it is a round mold, it would be easier and faster to rotate it and drill and tap another hole.

Thanks, Last time I had to play with non standard bullet weights when I was paper patching. I was more worried about speed than pressure and it was a bolt action. My core mold is spot on, so this...

Thanks, I appreciate the advice.

Thank you so much.

Does anyone know how to adjust a load if the bullet weight is not listed? I just snapped my spur screw on my core mold and stuck until I get it fixed. My other molds give me a 230gr and a 290gr...

Can someone give me a recommendation on who will redrill a spur screw on my core mold. Luckily, it is a round mold so it can be redrilled anywhere. It is a steel mold.

Thanks, can’t wait to see how they go.

I acquired a bunch of copper jackets and I want to know if I should anneal them or not. I have always used casings in the past. I was worried annealing might damage them.

Isn’t a 9mm .406 at the mouth? Can you use a standard sizing die? I am not sure on spring back. My .452 swaging dies are dead on and so are my bullets.

No problem, pm on its way. Great round.

I got both the insert and follower on thingiverse as listed above. Works great. I got them a few years ago, not sure what they cost now. I wish I had bought 1/2 a dozen sets....

I have an H&R. Used it to develop a load for 7.62x39.

I will take #4: 30-06 brass. PM on its way.

This is a great buy and addition to your pistol. I love cap and ball, but it is a blast to shoot 45 lc. Lots of cowboy loads available.

Me too. will follow up with a PM.

Making it from 308 is a pain, but it can done. I managed to make 3 good ones before giving up. Most attempts split. I got lucky and got in a group buy. A few of the auction sites still have it...

PM on solder mix ratio.

Same, too far south. Wish I still lived in Madison.

I too really like bullshop boolits. I have quite a few but, sadly, they are in storage and I am not sure where. If I find them, I will let you know.