Search:

Thanks, deltaenterprizes. I'm off this week and will try that. Papalote

I think mostly because you can. To try new things and have some fun.

Any ideas on what powder and charge to try with my 115 gr wadcutter?

Just for fun I think. Ultra light loads. I loaded them way back for a Charter arms Bulldog.

Like I said I pushed them up with a primer pocket swagger. I cut the bottom off a 44 special die with a dremel tool. I am making some cases but can't remember what I loaded them with. I have a 115 gr...

I made some cases. Trying to remember what I loaded them with. I ran the 45 cases up in a crimp die and over crimped them so they would start in the 44 sizer. I know I just had a RCBS reg press back...

Do any of the old timers on here remember a write up in a gun magazine about making 44 shorts out of 45 acp cases? At least 40 years ago?

PM sent

55.00$

PM sent on knobs

OK Sorry, I have some if the OP needs some

I load for a 585 Nyati. I use the big RCBS press.

6X45 is the same as 6mm/223?

I’ll take it. PM to follow. Papalote

What size is the belt?

I have a spare blackout factory crimp die. Let me find it tomorrow and I’ll PM you. Papalote

My 14 inch 7X30 waters is still available.

14 inch 7X30 Waters with dies?

I make mine from 357 max. They work just fine.

I'll take one of the three c presses. PM me with payment onfo. Papalote

I have a 22-357max. I just use a 222 Remington sizer. It’s a little shorter neck than a 222. Use it in a contender.

Contender carbine.

Is this worth the effort and where to find the dies needed? Thanks

I think I have a Lee 3 die set. I'll ck this afternoon.

I would imagine it has to do with time money and machinery. Just my thoughts.