Search:

Great stuff. I have been using it on the knives I make. Works great on the steel and handle material. Smells good too!

Mustard.

I have a couple of manuals for the Bullet Master. Will have to find them and get back to you.

Pre 2000 Jeep Cherokee. Add a decent set of tires and it will take you anywhere you need to go. They run about 5K, you can add bumpers, winch, tires and lift and still be under 10K.

Been using LEM for many years. Take a look at their website. They have everything you could need.

Check you messages

I have gotten them from Grainger in the past.

Ruger makes a model 77 bolt action in 7.62x39
Great rifle. My daughter gets a deer with it every year.

Clays has always been my go to powder for 308 subs

Pissing me off.

Sounds like leaking seal inside of the pneumatic cylinder. The seals can be replaced, depending on availability and if it would be cost effective versus replacing cylinder.

I have one made by Voodoo Tactical that was on a rifle I purchased. Look it up online. If it is what you are looking for I will send it to you. PM me your address

PM me you address. I will send you some brass.

I have many years experience as a custom jeweler and a bladesmith. Not gonna say it can’t be done, but it is going to be an uphill battle the entire time. Jade is a very brittle stone and difficult...

Search “NRA reloading bench plans”
Built 2 of these 35 years ago. They are great, no complaints at all.

PM me your address

I have dies and brass but no gun. PM me if interested

They are slightly smaller. I have about 5000 if anyone is looking for some.

Are the SP20 wads 1 1/4 ounce load? If it is I have some.PM me

I think I have a stock trigger. PM me you address.

W785 , H380, IMR4064, W748
High bid is $1.00 a pound.
Anybody close to Chico?

There is about 25 pounds of assorted powder in an auction ending October 30th. They will not ship so it has to picked up. When I checked yesterday nobody had placed any bids on the powder. Lots of...

I had the same problem on 2 of them. Called Dillon, the replaced the motors at no charge.

Always use a good quality handheld impact to remove plugs on these motors. This will greatly reduce any possibility of breaking plugs.

Hatchers notebook is a great read. Good section of him intentionally setting off many different calibers underneath a cardboard box.
Very interesting and educational.