Search:

the problems i have experienced with them has been in feeding + under hard use the staking loosens + come apart - what brand did you buy ?

jmho - any 158 grain swc loaded to sufficient power+ fits your bore should be fine -

jmho - every 513 repro i have encountered for Remington's have needed adjustment to function properly, even those advertised as being made on ex Remington factory tooling - probably better off buying...

just looked into RFC this morning, the topics that i used to post in - military trainers, Remington, Marlin, + legislation - quality has deteriorated greatly loaded with misinformation, opinions...

over the years the Ranger marking was used by Montgomery Wards + others - it was found on both Marlin + Savage .22's going back to the late 20's -

for those that care, Smithfield was purchased by by a CCCP Chinese conglomerate a few years ago -

fyi - i only restated it because it was in retort to fredj338 in post 57 erroneously claiming that i only had limited experience in powder coating - everyone is entitled to personal opinions + on...

many states have a spring + fall season + you are allowed to eat them at any time -

none of the previous comment about sizing apply to me, like i previously stated i only have any need to size my higher velocity rifle cast bullets when attaching gas checks - i have found no...

the CMP also does them -

i have not had to size any of the cast bullets in over 5 decades + lubing them with liquid alox allows me to shoot as cast - i definitely still find it expensive + time consuming + pc has never shown...

gave up on RFC after over a decade + 4,000 plus posts, i no longer will post there - since the site revision a few years back many knowledgeable users have either passed on or stopped posting also...

jmho - rather than alter spring tension, you might try polishing + lubricating all contact surfaces of spring + latch mechanism -

i would definitely follow randy, W.R.Buchanan advice on not...

[QUOTE=W.R.Buchanan;5716405]Don't mod the stock spring, mod the replacement, then you won't have to look for a new stock spring which will probably be harder to find?

Randy[/QUOTE

A+++ good...

jmho - it would depend on locking mechanism design - it might be a part that also helps keeps the breach locked under recoil on some designs -

yes they are quieter, but be very careful with some foreign produced CB's + both colibri rounds, had several cases of them getting stuck + no exiting rifle barrels at my range -

in my experience powder coating is time consuming + expensive + shows not one single advantage in any way over properly applied liquid alox + most conventual lubes -

jmho - before changing recoil spring try a different magazine - most of the time mag spring is not pushing cartridge up before breech block passes it -

town of 126,000 residents 15 miles from NYC + we are over run with them - known to attack kids on walking to school - we had none here till some were imported from Virginia - no hunting allowed at...

published industry twist optimal twist rates are
-
.22 short =1 in 24"
.22 long = 1 in 20"
.22 long rifle = 1 in 16"
special rifling for low velocity 60 grain heavy projectiles 1 in 9"
...

aside from fouling build up in LR chamber, barrels chambered exclusively for shorts have a different twist rate than the LR barrels , accuracy + sight settings will be different - shorts were...

Kai
New Jersey is only one of several states that have this regulation -
nj2c39 antique definition - state laws can always be stricter than any federal law as long as they do not conflict with...

possible limp wrist hold or soft grip ? - did you try a different magazine ? -

by federal law you can drop it off + have FFL enter into his book - your state laws may differ - check with ffl that will handle the transaction -

jmho - unless you are a custom rifle builder or barrel manufacturer, borescopes are a waste of money + cause more problems than they prevent -