Search:

Anything worth having is worth waiting for. Thanks John Taylor

I could ship it to someone who has a C&R with the original barrel screwed in. I have a Barrel vise and receiver wrench. I have a valid C&R

If they have a 4 jaw chuck and steady rest I can pay the bill. I'm not interested in a slop job

I could use a referral from someone who knows good work when they see it. I have a Lothar Walther stepped barrel for a K98 with .264 bore that is not chambered. It is threaded and crowned. I would...

I have encountered two types of Turk 8mm over the years. Light ball and heavy ball. The light stuff works pretty good in long barreled bolt action 98's like the model 38 and 98/22 Turkey used. I...

Those 7.7 Arisaki actions are strong. You can fire just about anything it will close on and neck size from there. 303 Data will work all day long

The 0 ought bar is for red dot 3 Drams Trap load.

I'd buy one tomorrow if they came in 454/45 Colt . You would think with as many offerings that Henry has in 45 Colt repeaters that they would consider it and the .357/38.

Staying to the light strikes thing I will say that the piece of glass on my bench has helped me detect a lot of high primers over the years.

Well I bought me a 4.2 convertible 45ACP/45Colt and need some sound advice on what to feed it. There is some question as far as sizing goes and I really don't want to start reaming the cylinder on a...

It wont be difficult to achieve those velocities. I would go with gas checks and rifle powder. 4350 or 2700 is my go to and seems to work right around starting loads give or take. Most 8mm's like the...

Left hand bits are very good stuff. The part about taking a piece of hot brazing rod to the head is very good advice. I have taken a electric screwdriver or drill and chucked a stiff piece of a hat...

That's a first. I've never seen someone use a cross pin for take up. You need something that you can adjust.

It's the cocking piece (to short). The sear and trigger look OK but all this must work together. I take it either doesn't stand cocked or fires when closing the bolt. When doing a safety check after...

As a young man I switched powder bottles on a Mec 600 jr. It had the red dot bar in it for trap loads and you guessed it Alcan 5. Before I stopped shooting them it split the forearm on a nice old...

My RCBS Trim/Form die is the greatest. Pull it down then whack it off in one lick with hack saw. A VLD chamfer tool is helpful

Well it looks like I should by a lee and the NOE spire point mold. I need to slug several of them and see where this is going size wise. Thanks to all for the advice.

I have over a dozen K98K's that I shoot. I have a 5 gallon bucket of chilled shot, some hard ingots and several very large heavy rolls of 55/45 solder. I bought some 174 gr GCRN that I tried with 18...

What do they drop at?

I want to buy me a mold and some Gas checks and perhaps get someone to make me about a thousand on the half's. I have a bunch of lead and solder that I could roll into the deal and really not in a...

You will not have any trouble with the shoulder until you get to .400

He was probably going to shoot you with that 32 and call 911 with your cell phone afterwards

Thrived might be a better word. I'm not sure that JMB was the sole designer of the Hi Power and several improvements have been made over the years. The magazine was way ahead of its time. Hi Powers...

Sounds like their stupidity is costing them $. I sure hate that.

Or XD service model