Search:

Thanks I will be making a trip to Harbor Freight , carpal tunnel just as bad

Ok, So I Now have a MR. Bullet die in .40sw and have ran over 2k cast powder coated and not one hitch. I had some lubed bullets that I did before i started PCing. So i tried a couple hundred and...

Prayers are lifted towards W TN

I have the XDm in 9mm, .40 S&W and .45acp and yes they are all tack drivers. I shoot 80% lead cast. I will check my load data and get you what molds and loads I use for each, I would think my .40...

I agree I have stopped most of TV, then working from home and doing my shopping on line I have found 8-10 hours a week to do things I used to do before watching too much tv

Ok, to start with this is not B S , two years ago I shot a deer with my cast lead bullet and had a good shoulder hit. the bullet lodged in the front shoulder bone. For fun I dug it out. Now I...

I love the Mr. Bullet Feeder, works with any cast i have put through it. powder coat, lubed, homemade lube. I will eventually have one for all my calibers.

I used a 2.5 gallon bucket on my vibrating one.

My manual lee collator does great on all my hand gun loads, i use a single stage for most of my riffle except .223. Does anyone else have issues with their .223 brass falling in the tubes, or am i...

I have a Dillon, but use the Lee factory crimp for all of my 9mm, .40 and .45, Tested with and without using it and my group at 15 yards was a half inch tighter using the Lee dies. I will never own...

I can't complain, it is the first pot I got and have used it for over 10 years casting over 100k plus. It drips a bit and I have to monitor the temp. but it does the job.

Test pix of my Dillon 550.

I agree the red is ok, However I picked up 2lbs of black with the 20% coupon and so far it seems to have been just fine. done 3k 9MM HP

will you be running your cast bullets through a sizing die?

can you keep in the fridg

Finally!! Got drawn for an elk tag in KY, bow either sex. Does anyone have advise on where to hunt or property to rent or a guide to hire. I did check with one guide and his price was more than...

Awesome, do you use cast bullets also

Has anyone had any luck using a Mr. Bullet Feeder die on a Dillon?

I have one at my office, there are days I work 12 hours and then days I have hours to kill waiting on the phone to ring. I have it for about 7 years, loaded 1000s with it. Perfect for hand gun...

I did on 08.10.2020 no call back. Same on 08.11 got a call back in about 45 mins, got the warranted piece the follow Saturday

I just bought a SS for my Dillon 750. I have had it about 2 months and have ran more than a 5 gallon bucket through it. I have now loaded about 3k rounds with less than 1% problems. So yes I love...

Very rarely do I have a issue with my food saver, out of freezer into microwave or boiling water. Have to admit nothing usually makes it over 3 years.

after the unmentionable parts, I take one of the back legs and make jerky, some may say it is a waste of the roast, but I have loved good deer jerky since I was a kid

Wow, was not expecting that kind of price tag. But will look into some of the less expensive ones

Thank you, I will look into. I learned to shoot on a bb gun, who knew that they would have come this far.