Search:

It actually feeds well from pmags only

I am loading these 247GN RN NOE with 9 grains of H110 for a suppressed 8.5" SBR AR15
Does anyone know the minimum powder charge. I don't have a chronograph to determine how far they are above the...

I have 55gn gas checked .223 cast bullets I got from a fellow member a few years back
I need a load data for h4895. I used to have it written down but my notebook was destroyed in a move. Thanks in...

247gn flat nose bt powder coated

Any on have any load data for loading cast 300AAC BLK Out Subs

I have been hand loading .270 with nosler bst and using a lee die set. I have a rem 710 that has a 4rnd box mag. Sometimes they get thrown inside the brass when i shoot the round in the chamber. I...

The Kenjudo's setup?
Is there a detailed set of instructions to duplicate this pot?

what are the diameter specs on what yours are dropping at and do they have gas checks on them already?

I would like to know if anyone has seen where I can get a mold that will cast 180 gn .277 -.280?
You anyone comes across this and wants to sell a hand full of ogives that I can test fire and decide...

Has anyone here tried to cast these in .224 or 5.56 mm?
I am looking for at least a 75 gn round with a gas check so I can shoot slower rounds with out the wssm barrel burning out.
Please share what...

show if this is the magama lube is this a good oops creation or a bad oops creation?

Yeah I only shoot outdoors. I was just messing around when I made the batch. I intended to make a tumble lube and ended up with a pan lube. It seems to stick to the rounds very well. and everything...

So I started out to make a variation of the Johnson's and Alox Tumble combination and ended up with a very hard high heat pan lube. My contents were Johnson's paste wax boiled to remove solvents,...

So i tried this with my latest batch of ingots. They were the best yet. Far better than wax or saw dust. This is a must for me!!!

57084What would you suggest for the charge. I found that load online but it was for a 125gn and now knowing that they are 133-136gn I have to find a new charge weight. The test fires were very heavy...

they are 133 to 136 grains

they drop at .356

Do you have to size these bullets from this type mold? Also what lubing process are you using on the rifle bullets?

Nice I will def use this on my next batch

ok ill check the pot i bet it is sulfer. The lead I have been getting has a high sulfer content from the ground here. The smelting pot turns yellow on the outside when melting large batches. After...

yes that is way to high. I normally get them for 15 a bucket. I have been getting lead from a local range that pushes everything out of the back stops with a dozer for 10 a truckload. this usually is...

def a good question how did the lead turn out? I have tons of paper shreds if this is the easy source then I am g2g

Ok so the mold package says lee 124gn tumble lube lrn. It however only has 1 groove. I removed the bullet seater and ran the brass through and it fixed the bulge on the brass. I went and test fired 7...

OK I kinda figured just mess with it until it works. I also discovered the bases of the brass are ballooned, my friend that loads says this is caused by getting cases fired from a Glock. Is there a...

I have a 10LB Lee Production pot and I use it only for melting and pouring clean lead. I poured out the remaining lead and discovered that the bottom of the pot is rusting. What can be done to slow...