Search:

SPF to ShootR

Lyman 452460 with handles

Lyman 452423 with handles

Lyman 358242 no screws in this one for mounting handles and no handles

All three are single cavity

Take all for $95 shipped...

Price drop.

I guess I forgot to post about the TC mold. It is a maxi hunter bullet and I have completely forgotten what the bullet weight is supposed to be. I will do some research on it.

This is in good condition and functioning well. $100 shipped

299315

Closed and reposted with lower price

RCBS 40-180-FN 2 cavity $85 SPF with handles
Lyman 452374JV 4 cavity $85 SPF with handles
Lyman 452423 1 cavity $55 with handles
Lyman 358156LW 2 cavity $65 SPF with handles
Lyman 452460 1 cavity...

Bump

299291299292

These both work well and the RCBS comes with the ratcheting wrench not pictured. I have several dies and top punches that can be bought as well but did not have time to list them...

This is a Lyman Mould Master XX that works good with a good cord. $150 OBO shipped.299246

Probably your article I read that got me wanting to try it out. Thanks for the tips and info guys!

Dippers, or diapers? �� Thinking diapers might be needed with an overcharge of that magnitude!

I just ordered the pistol and I have this mold already. It shoots beautifully in a 625 JM and believe it or not in the beloved by all and high $ High Point Carbine 😉. I am hoping to get some...

I seated to where 90% of the crimp groove is inside much like in AR brass except no crimp. Tried it and it fed fine in my application. Failed to measure it.

I have no doubt that there are guns in which it will not feed well. I am just pumped it works so well in my carbine. I also have a 452460 mould that I have yet to try. Gonna try that Keith boolit in...

I have posted previously about my success with this bullet in my 625 JM in AR brass. On a whim at a recent gun show I decided to try my first cheap gun. Bought a Hi Point carbine in 45 acp,...

The 44 special flattops are winners for sure and mine is deadly accurate out at long range too. However, no reason to not have a magnum. I discovered the BFR shorty 44 magnum recently and picked one...

I do believe that the first time it clogged due to failure to properly clean it after extended non use and the last session. The second time was due to freezing since I was trying to lower the temp...

I have been reading and collecting casting equipment for many years but for some reason didn't get around to actually casting until a couple years ago and since then only about 4 sessions. Got a...

In the market for this mould and I see they about a wash for price. So I believe the NOE is true to Elmers design but the Lyman is a cast iron mould. Experiences, recommendations?

Lead fumes are toxic and cause brain damage and by the time Al Gore got around to inventing the internet, the founder of this site had already cast many a bullet and the damage was done! Since gun...

Love this gun. The JM grips felt a wee bit small for me which is odd considering my hands are not large but they have grown on me and now I love them. The trigger on mine is fantastic in both double...

I have mould envy!

My 625 shoots awesome with jacketed bullets but not quite as good with the LRN Lyman bullets from the only 45 mould I have. I bid on and won a 452460 mould and am also in the market for one of the...

I was with a friend who fired 9mm through a .40 M&P with no ill effects other than severely bulged brass. Can't be too careful with guns though. I was shooting the same M&P on a later outing and...