Search:

Bill,

I actually bought the pan myself many years ago from what was then our version of Walmart.

Its not a fancy looking design, just the sort of thing you might see in a commercial kitchen,...

Thanks for the warning, I never knew that lead had been banned!

I scrounged these a few years ago knowing that at some point in the furture I'd like to try casting, and i would say that the are ...

No, the aluminium "core" is on the underside of the base of the pan..This core then has a SS cover over it...The inside of the pan is plane SS with no seams ect...

I am going to take folks advise...

Not at all...However it a useable pot right now and I would hate to ruin it for kitchen use by smelting in it, only to find it was suitable after all...



If the existing pan is not suitable, I...

I am just in the process of getting started in casting.

For the initial smelt of my WW, I was intending to use a SS saucepan from the kitchen...

The pan is of decent quality SS but I notice it...

The most basic "shooting bench" I saw was in one of the American shooting magazines several years ago..

The writer wanted something he could leave on site that was unobtrusive/low key that would...

Pat,

It all depends what you want the bench for..

Do you want an easily portable bench? A heavier model that is "movable" or a permanent rock solid affair as typically found on a well set up...

Thanks for the advise and encouragement...Just had a rummage through our kitchen cupboards and found a largeish SS saucepan that I am sure the wife doesn't need.

The Stainless steel handle is...

Hi Folks,

I would like to start low volume casting for my 9.3x62mm, plus things like fishing sinkers ect..

This project has been on my mind for a while and after a little research I started to...

Thanks gents for all the advice and encouragement, and my apologies if I posted this in the wrong forum...

Looking around the site I can see it is a huge resource of information, idea's and...

Thanks for that...I suspect those bread tins would be ideal for what I need..

So I take there should ne no issues with the lead "soldering" to the stainless? I

would think the polished...

Hi Folks,

I am just about to dip my toe into casting for my 9.3x62mm, and I thought for my first step, I would melt down my wheel weights into ingots..

I have read some of the various threads...