Search:

I shoot my Parker PH with twist steel barrels using 7/8oz loads under 6,000 psi using published data. Have your barrels gaged and inspected by a side by side specialist before shooting. If your...

324570
324571
324572

Well here is the rifle after full disassembly and deep cleaning. It had been stored for almost 50 years, and really needed it. Thankfully it was from the dry Southwest US....

i committed to buy, working out the transfer. Thank you for all the feedback.

Fantastic case coloring. What a nice project.

I’ve been offered a nice condition Winchester Model 94 in .32 Special with a Lyman 56A receiver sight. Since this is a pre 1953 rifle, I am assuming it was drilled and tapped by a gunsmith to...

I came across a discussion that suggested Winchester 94 32spl barrels have a slower twist, and thus are better for shooting cast bullets than Winchester 94 30-30 barrels. Is there really any...

If you have a MEC 600jr, buy the “short kit” from ballistic products. They also have a tool to shorten the hulls. I fold crimped, but roll crimping with an overshot card works too.

I think CMP will install the new barrel, for a fee of course.

Longbow, I’ll be using these in a vintage 1970 Ithaca 37 20in Deerslayer. I understand these are cylinder bore.

I’m on my way down the slug reloading rabbit hole. For those of you shooting Lee slugs, particularly 7/8oz ones, should I be using pure lead to cast or would mostly wheel weights be ok? I’d like to...

I have a new to me TC Hawken flintlock in 54 caliber. I have Goex FFg and FFFg propellant powders, and FFFFg powder for priming. I also have .535 diameter 230 gr round balls. Barrel length is 28”....

Minerat, thank you very much!

My apologies, it is Speer!

I’m looking for .243 Winchester data for the Speer .243 105 grain hot cor bullet. This is discontinued, and I’m not finding data online. Does anyone know which edition of the Speer manual has this...

I’m going to be receiving a Winchester 1887 which is missing a few parts. At this point I don’t know what to expect. Does anyone know if the parts for the Chiappa 1887 reproductions are...

Hmmm. No wonder I can’t find one....

Ok, I know the answer is going to be “have you slugged the bore”?

So, the answer being “no”, I just cast about 30 boolits using a nice vintage Lyman 454190 SC mould. The average diameter of the...

Thank goodness only the sight was broken and that you are ok.

I bought my first Blue Sky M1 at a department store in Columbus, OH in the late 80’s for less than $100. The crown was shot, and I replaced the barrel with one in the “correct” date range, and...

Hello,
Has anyone used one of these no drill scope bases? Appreciate any thoughts.

This morning I came across four old 1903/1903a3 walnut scant stocks that were unfinished, unused, and unmarked. Each had the stock reinforcements bolts added. All had some damage, they look like...

I just bought a box of these from Midway for my Russian capture K98k. Downloaded the Speer data, and I have both IMR 4064 and 3031. Anyone play with this bullet and have a preference? The rifle...

303312303313

Many thanks to everyone. I bought it, it’s in fabulous shape. Slight mark on the blue near the muzzle from a holster I guess. Comes with ruger special edition case, boxed extra .45 ACP cylinder,...

I’ve been offered a very nice condition 5-1/2” 2001 Ruger Vaquero in 45 Colt with extra 45ACP cylinder and 200 rounds of factory ammo. Finish is blue, frame has a case hardened looking finish. ...