Search:

well you have heard of hens teeth
would be easier to find

spring tool for small engine valve work

would say a bit short,
just a caution many times ALL did not fire, so be careful

they will send it to ffl and guess what ? hope he is friend

your major problem with paper now is about 1 reload, they are very thin and will burn or split at the head

drill dr is good for 3/16 up

just toss the small ones

if you do the limb saver
you will need to store rifle barrel down. they have a pin for them but it is soft and will break. and time will make them sticky

i will list in swap/sell

your problem is the ---gas check--- that wont work for international shipping
been there

the lifter dont work good for shorts . i have shot some , kind if manual the rem hi speed would do a few. auto. but
only ammo i had a problem in LR was the win wildcat , it would ...

well i will get a pic
my only problem was the receiver cover is not connected to the barrel. a scope wont stay 0 it will move. so used it open sights till eyes got old

is there much of a market for them?
i saw few yrs back the green was very HI dollar
i have the brown.

make sure you get them hot 160F for about 10min
its not so much for the room as for stuff that can be on them

dont think it was polished correctly it NOT the barrel
take a 22cal bore brass brush put some of the BLUE scotch pad and a drill with some soda it will hone it
ONLY use the BLUE not green...

the soles are trash they come apart tops is good but soles are trash

sand will clean the bowl pool sand is best

a 45gr lead small rifle mag primer NO powder 50ft if you want 100ft you will need the load larry posted . but 2gr is pain best may make dipper 22lr case 3/4 is near 2gr
Lee had...

you cant go wrong with the LC pricey but you get what you pay for not sure the shaft will fit a lyman

well here is what you will find. i would not try a 279 in a win 70 it wont chamber
if you have a tight chamber like one i have 277 is only thing that will feed
the Lee i had was 278 it will...

well one thing is shipping and control on BP
last i got from the reenactors he told me 3 yrs back that it would not be long before they had to go to pirodex . they were trying things to make...

now you are getting in some parts that Dont interchange
the big recoil that goes mag tube is same rings are same extractor is rem 11 barrel is rem 11 bolt is rem 11 type

if gun...

pietro is correct to point stock is same all were round grip barrel NO
12 and 16 used same are looking for the main mag spring
google that,ebay , now one in the stock is a gun part

if you are doing cast
take the insert out
will save you lot of grief
been there
that better be a very good scope. 460 will blow most up

have been looking for a light 338 jacket for last 3weeks
all are out of stock
i found box from place i didnt know sold reloading stuff

feel the top edge will be like gator teeth
is Dr blackmon