Search:

I have 2 sets of dies one is for a .45, the other one is for a 40. Iwant to trade them for a .217 set . thanks Bogone

I guess not many people have bullet squishing stuff.

I have 3 sets of dies for .40, .429, and .45 with gas check makers. Would like to trade for something in .30 cal or .224. or sell. They all are wad cutter design with hollow pointer top punch.
Thanks

I have a set of Corbin LSWC-S .400 FB Keith Ext. They are new. Want to trade for Corbin S dies for a .308 caliber.
I also have the same set for .429 new also for trade. Thanks

I'm in if I can purchase,beg, borrow or trade for some .30 calibre projectiles from some one! Got lots of stuff to trade.

Primers are all over the place. You just have to pay$$$$$$$

220 swift might as well have the best.

Did you ever try unique? The reason I ask i need to work up such aload for a 223 and I have lots of unique powder.
Thanks
Charlie

3031, 4064, varget, unique

They will also do up to 3/4 jacketed bullets,and lead boolits.

I always warm my mold up on a hotplate and it drops good boolits after just acouple of pours. I have to set my hotplate on the low to medium setting or it gets to hot.

I priced all the stuff out on the Corbin web site. There is approximately 3200. Dollars retail on the tooling and 1250. Dollars of lead wire retail. I have .45, 41., 40. Pistol dies.

I may put a Corbin type 2 press up for sale with all of my goodies if there is any interest. I have the press, 6 rolls of wire, 3 sets of dies for .40, .44, .45, wire cutter, base guard kit .40 and...

Bump for a really good thread, should be a sticky.

Bump for a really good thread, should be a sticky.

Bump for a really good thread, should be a sticky.

I'll throw my two cents in here. I own a cnc machine shop and have some measuring equipment. I recently did a job for Uncle Sam that had such wide tolerances that you could use a tape measure. The...

Bump for a really good thread, should be a sticky.

Bump for a really good thread, should be a sticky.

I just purchased a set of new Forster 220 swift dies for 45 dollars of flea bay.

I have a mihhec mold and the penta pins stuck bad. I removed them and lapped them with a 400 grit diamond lap, one problem solved. I cast about 10 lbs. in an hour, now in am having problems with lead...

I have a brass mp mold and it has casting lead stuck on some corners. Is there an easy way to remove this? thanks for the help...

Very good information you guys gave the gentleman buying his first lathe. I started 30 years ago with a 9 inch south bend, trade it off and got a 14x40 southbend, traded it off got a hardinge hlvh...

No I am looking for some suggestions on a stable boolit. I was thinking about buying a few from the guys on the forum to try before I purchase a mold. I do have an lyman 311041gc to try. Don't have...

Mine will be here on Thursday........ Yeah