Search:

Is anyone shooting 115g cast bullets(ie Lyman 311359 mold) in 300 BO?

Thanks guys

Has anyone used 16-1 alloy for 38 wadcutters? I’d like to powdercoat some for light plinking loads.

I have run them through dry, but I’ve read that it’s not a good idea. The only reason I can think that it’s a bad idea is that it may foul the die with some lead. I’ll check into the Klein synthetic...

Not sure if this is the area for this question.
I want to size my 44 mag 240 grain bullets prior to powder coating. Does anyone have a lube that will rinse off easily after sizing in A lee sizer...

Thanks guys. I’m going to look into the nuggets once I’m done with the bars I have.

This may be a silly question.

Does using a propane torch to melt alloys such as rotometals super hard affect the properties of the alloy? I ask because I am starting to use these metals to adjust...

Thank you. I sent him a message.

I came across around 70 ingots of “lead” that I got from a guy who made fishing weights. He says they contain mostly lead, solder, and tin. I did pencil hardness test and Lee hardness die test and...

I can't seem to find the alloy calculator. Can someone kindly share the link? Thanks in advance

I have some ingots that I make fishing weights from that is pretty soft(similar to wheel weights). I’d like to harden up this unknown alloy to make it suitable for gas checked magnum loads. Any advice

I found 2 bars of this alloy. It appears to be

89% tin
8% antimony
3% copper

Does anyone know if this Can be used to harden lead for casting bullets?