Search:

How did it feed with the fat case ?

Jeff Tanner has reasonable priced roundball mold a in any diameter.

Mine throws 358 . I size for snub 38 ,9mm and 380.

I have one here somewhere , came off one of the 'cigarette' rifles from WWII .

True to some extent . Not all reamers were always cut to same dimensions for same cartridge designation . It used to be deep dark secrets with gunsmiths !

375/303 and the 405 (although the latter shortened a little) work and shoot beautifully through the LE / Smellys !

I had to make an magazine insert to feed cartridges single stack . Other than that the SMLE action works great for 405 !

What scope mt is that ?

I still have quite a few of the old lathe turned nosler partitions . 50 count MTM box loaded in Win 30-06 cases with milsurp 4831 in boiler !

At one time the breech plugs and bolsters threads were epoxied into barrel !

I have a pattern of magazine insert I can post . It works well with both 375/303 and the shortened 405 I put together .

I have a 9x57 in progress on a 91 mauser carbine action I swapped for . I used a Rem 350 mag barrel chopped threaded and rechambered for 91. Stock is a Boyds . It is going to be quite lite and handy !

Several types done over the years and kudos to justashooter for sharing his ak rec. forming tool designs and methods !! Helped me and several others down the path !

Cool !

No slouch for sure !

How cool is that !!!! Makes for a nice thumper ! What kind of velocities do you figure you're getting ?

Source a couple used hot water heaters and gut and flush them out .

A couple pressure tanks for a well water system would be a better solution and arent all that expensive . I have a 125 gallon pressure tank for my well that I installed when building our house .

Hes a few states away kind of neighbor .:kidding:

"Unless ya have a neighbor..... LOL"

Wow! They didnt give that away did they :)

I think I can make one of the valve and burners . I made my own for bluing tanks years ago .

Thanks Garry !

The brass pipe that has serrated wheel on it , that nozzle . Most are a wire gauge size .

Great stuff Garry ! Very cool build alongs . What size is the orifice in your burner nozzle ?

I made up a 375-06 on a FN Mauser 98 with no problems which comes close to a 375 HH . I also made up a 375-338 on a VZ24 with very little monkeying around with feed rails to get it to feed . The...

I probably missed it , but are you using straight 223 casings ?

The stock is Oregon Myrtle . Grows on coast from northern Cal. up through Oregon coastal area. Grain is nice but a bear to work .