Search:

I have done this but it continues to move when casting. I think they need to be pinned at this point.

I have a 8 cav aluminum mold, and the steel alignment pins are walking out. Unfortunately I am getting zero response from MP molds. I have been trying to reach them over the past few weeks. Any other...

Anyone ever make granules big enough for cannons? Say 2.5" bore. Something to replicate Goex Cannon?

I am referring to the actual chamber of the firearm

Has anyone opened the neck up on a 300 blackout barrel with a 7.62x39 neck reamer to 0.340” to accept cast loads with converted brass more readily?

I’ll give this a go. I can weld the spout solid to fix that leak and I’ll lap it where the valve seats

No other suggestions?

I may be able to. I ripped it all apart and straightened and cleaned it. The problem is where the valve stem seats at the top of the valve it is slightly warped. Not sure if I will ever get a seal...

Good Day,

I purchases a used pro melt that I am finding out has a couple of issues with leaking. I looks like the nozzle may have gotten bent a bit and now it leaks around the spout and out of the...

How do you like the 95gr in 9mm. I use the exclusively in my 9mm carbines and love them.

I have had mine for a week or so. When you get your molds in check out the size of the holes in the sprue plate. Mine were too small to get proper fill out. I had to take a sprue plate off another MP...

Got mine the other day

Would any of this be pewter. These are pictures from an online auction. So this is all the info I have. They refer to it as silver ware
...

Interested as well

Any more interest? A very similar 95gr bullet works really well in my Fx9 and CZ Scorpion.

I would go for it in an 8 cavity

I may try plain base pc in an sks and vz58. Nice thing about these guns they are typically way over gsssed and can operated the gas system at fairly low velocities

Has anyone had any luck with powder coating or hitek costing 22 cal plain base bullets in the 2200fps range.

I am looking to built a load for a Troy PAR and a Ruger gunsite scout

Any interested in running a group buy on one of these. No lube groove option 8 cavity aluminum?

I probably should do a chamber cast. I will get back to you guys with groove diameter

Good Day Folks.

Hoping to get some onsite into some leading issues I have been having. I have shot thousands of rounds through various 9mm handguns and carbines and have never been more than a...

Ok thanks guys. That’s kind of what I figured. I’ll start another thread on the particular issues I am having.

Good Day Folks

We all are familiar with bullet diameter/fit, alloy, lube, coatings and the effect they have on leading in the barrel.

What about high volume shooting and a hot barrel? Is it...

I’ll take one. gvanzeggelaar at yahoo.ca
8 cavity 135gr .358 diameter. Plain base.

Any word on these?