Search:

+ 1, Really like the NOE 432-266-WC-PB in a 44 Mag case, crimped in the top grove, over 5 gr. ~ 6 gr. Promo /Red Dot. Accurate and easy shooting in my SW 629.

Finally found the thread I remembered. Good research on the effects of quenching. I keep a copy of the chart in my log book .

https://castboolits.gunloads.com/showthread.php?453167-PC-Questions...

The NOE 432-226-WC seated to the crimp grove in a 44 Mag case gives you the same "boiler room" as the Lyman 432421 loaded to the crimp grove in a 44 Spl case. For me, the NOE WC over 5 ~ 6 gr. of...

+1, way back when, I consider I wasted money buying aftermarket barrels for my G22 and 21. Now I have proved to myself with thousands of either lubed or PC'd boolits that Glock OEM barrels work...

Another vote for WSF. Blue Dot is also outstanding in 9MM along with Red Dot/Promo.

Totally agree with Country Gent, boiling works perfectly and leaves your 450 good and clean.

I've found the NOE 359-121-RN (Lyman 358242 Clone) to be super accurate in 9MM, 38 Spl and 357.

JB Weld works for me.

Sorry just measured , I was away from the house, you need a 1/4 x 2" bolt ( not 4"). My bad!

I use 1/4" x 4" hex head bolt....recommend using Grade 8.

I’v bought brass there. They are good people!

I also have the Lee 102 gr. but I much prefer the Lyman 356242 (90 gr.) for .380 in my Bersa.

I use nothing but range pick up 223 and 308 and got real tired of screwing up decapping pins and rods. Several of my die sets are Lyman. I screwed a Lyman Decapping Rod for Universal Decapping Die...

Totally agree! Soak/wash it in hot tap water with a big teaspoon of citric acid powder ( or Lemishine) and a big squirt of dawn for 30 minutes will usually take off all the tarnish. After air...

I like WSF, Blue Dot, Promo/Red Dot in that order.

My 45 ACP Mech Tech CCU with dedicated LW Timberwolf (G21) lower is fantastic.

I've used many K's. They work just fine.

+1 I do the same. Also, like 405grain recomends, if you punch the GC into the case you can dump the powder and then invert the case and grab the GC at the neck with pliers.

I have a 35 cal Pat Marlins PB GC maker and I use soda cans for the gc's for plain base .357 Mag. boolits (works fine for 9MM also). I seat the gc's with my Lyman 450 and agree its a real PITA to...

Same here. I like it better than the GP100 too.

WLL 2500+ works just fine in my Glock 22 Gen 3 OEM barrel.

I size most all boolits with my Lyman 450 and most all my boolits are PC'd so I seldom lube. I do occasionally use a LEE push-thru for 30 cal that I expanded to .310" using my Lee Classic Cast...

I just sold my Hi Point 995TS 9MM but NOE 359242 (120 gr) powder coated and sized .357 worked perfectly in it.

+1 for the Lyman 356242 (90 gr)

I shot K's of Fiocchi primers. Never had one fail to go bang.