I gotta try this with the 500 mag :)
Type: Posts; User: DanInCt
Forum: Classics & Stickies
I gotta try this with the 500 mag :)
Forum: Classics & Stickies
I was melting down some stink pipe and one of them had some water in it.. and well.. always wear protective equipment. For my initial melting built a ledge by my pot ( old line man pots for...
Forum: Classics & Stickies
Looking for online data for powders/bullets in a format i can pull into excel . Anybody?
Thanks
Dan
Forum: Classics & Stickies
I keep the brass pretty warm, i hit it with a temp gun quite often. Seems the larger the cast the easier it is for me.
Forum: Reloading Equipment
When i bulge bust unknown brass i have to take the crimp apart and put in the part they sell for truing ( glocked brass) . Are you saying it swadges bullets under normal crimping? I wouldn't think it...
Forum: Gas Checks
The designs they have up at the top of the check forum is nice. If you know somebody good with a lathe you could have one for pretty cheap, thats the route i went.
Forum: Gas Checks
If i shoot without gaschecks on a gaschecked bullet I tend to drop to the lower end of the powder charge.
Forum: Gas Checks
Thanks for these plans! You know its hard times when gas checks are in demand!
Forum: GB RUN BY Lakehouse2012
Lakehouse, Drop me off this 75 grn mold. Ill stick on the lighter one though. Thanks. I have a different kid to feed who needs a mold now.
Forum: Group Buy Discussion
I have interest in 7mm, i pinged him a while ago but i guess he is super busy. I would like to feed my 7mm mauser . A nice pinned mold would be great
Forum: GB RUN BY bluejay75
Did you get me on this buy? The list doesn't reflect it. Just wanted to make sure i get in on this.
Thanks
Forum: GB RUN BY Lakehouse2012
I think so. I read the posts, never made it to an offical meeting but go to the rallies around here.
Forum: GB RUN BY Wasalmonslayer
4cav gc hp with all pins please
Dan esc h n er At Gmail dot com
Forum: Group Buy Results
sent him an pm.. not sure how you get somebody to start up one of these... but there on some lighter grain moulds on his website... but id love a 700 too
Forum: GB RUN BY bluejay75
daninct - dan eschner AT gmail DOT com - HP- 0.432- 2 cavity + pins PB - 06791
I pm'd too incase you needed on the thread
Forum: GB RUN BY Lakehouse2012
3 cavity HP lube groove gas check + pins 75gr daneschner at g mail dot com
Forum: GB RUN BY Lakehouse2012
6 cav for 65 grain + groove gas check. daneschner at g mail dot com
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |