Search:

Daughter had hives last yr, died off so she moved them and is trying again. Either mites, poison or drought got them.

Wonder what the recoil is compared to 308/223?

Cast a pile of 145gr PB for the BO. Just checked, got 2 1/2# of 2400. Lucky me.

Deer @ 100 with Rattler. Base mag x 2.
327024

BO CVA 110 vmax and 135 FTX. Decent.
327023

https://www.breitbart.com/local/2024/05/25/god-lit-match-12000-baptized-california-historic-worship-event/
Praise the Lord.

https://www.agmglobalvision.com/thermal-imaging/thermal-weapon-sights/agm-rattler-v2-19-256
These work good but rather large for a pistol. Would be good for the 10/22.

Anyone find a trigger group/receiver parts diagram? Mine is hard to open now even when empty. Lube with kroil seems to help a little. IIRC military cals are restricted in EU.
Yup, clean with brake...

326850
This works real well with the PID attached. And I don't knock over any rifle bullets.

GCd some 145gr and PCing for BO.

If using google mail, might be them. Or your cookie settings. AVG may be blocking.

WSF works fine in 40sw with 165gr cast. About the same as hp38.

Cast a pot full of 9mm slugs. Shoulder is tired.

Molecules move around in a solid metal, higher temp, more movement. It takes time at temp to get them arraigned right. Temperature of quenching water determines the rate (faster is better) of cooling...

Drying of nitrocellulose is very dangerous.

Just check used car lots and national sales Co. Her sis got a used toyota with side ramp. He passed earlier this yr and she sold it for about 10k$. They are around.

Had double done a loong time ago, doc told me to quit riding MC for a while. Otherwise, pain recovery but healing was complete. Just move slow and don't over stretch anything.

Why would anyone getting a Ruger #1 think they were a moron? If only I could afford one.

In several years of shooting pistol/rifle with HiTek/PC/lubed I've not seen enough difference in accuracy that can be attributed to the 'lube'. Powder/alloy/load makes too much difference.

I tried the spraying/baking plates long time ago. I shot AR10 308, several 300BO ARs. NO problem with gas port. Carbon and lead can cause a problem. Mine are adjustable, tweak the screw every once...

I just put a known alloy bullet in a vice with unknown, squish hard. Look at the dents on both to determine if it's 'good' enough.

Most of eastern side of Ne has been taken over by Mexican/Arab peoples. Expect the rest to go also, just like the smaller Ks towns.

Reminds me of trip to Fl, son wanted to fish off the bridge. Got a blowfish and then an eel. Had to get the side cutters to cut the stainless leader. He wouldn't get near it. Now his company says he...

Grind off 50 thous of the bottom of the die (not shell holder - they are HARD). Screw down the die extra 1/2 turn and size a case. If the bolt closes with little resistance, that's good for YOUR...

Spank it.