Search:

Pulled all the XTP's, and saving the R.P. brass for LSWC bunny burp loads. This time I used FED. and WIN. Nickel cases, Gave all a hefty push test before crimping and they didn't budge from the...

Yes, after doing a bit more research I was told R.P. brass has this problem, And all the R.P. brass seems to be the culprit, (I marked the primers on the loosest rounds when seating, and all were...

country gent, seating operation seems to be working as normal, with proper seating rod for the XTP's
Thanks, Paul

Thanks for the input MT Chambers, I may lust get some new brass, I think this stuff was worked even before I got it,
Paul

using single state everything, RCBS Rock chucker press, RCBS powder drop, I Seat bullet, then back off on seater and apply crimp separately as last step, With RCBS 3 die carbide die set. Thanks. Paul

using single state everything, RCBS Rock chucker press, RCBS powder drop, I Seat bullet, then back off on seater and apply crimp separately as last step,

Have both calipers and mic's, my dial calipers are very accurate, which I used, I only used 2 dies, (sizer and bullet seater) did not use the belling die,
Your knowledge is much appreciated,
Paul

Just now mic'd inside diameters, Both brass and nickel are .354 thousands, XTP Bullets are .357, and the cannelure is .340. 357 Magnum rounds worked fine.

Don't know if I am in the right forum, But here goes,
So, am loading 38 special in mixed brass cases (all brass is sorted in length within 3 thousands) , Oregon trail LSWC (358) work fine, BUT,...