325673
I bought this old 1895 in 8X50 years ago, she's pretty worn but still shoots pretty good.
325674
I've never actually tried any load development with it. I started with the CCI LRP, 16...
Type: Posts; User: hpbear101
Forum: Military Rifles
325673
I bought this old 1895 in 8X50 years ago, she's pretty worn but still shoots pretty good.
325674
I've never actually tried any load development with it. I started with the CCI LRP, 16...
Forum: Factory & Surplus Powder
My dad had two 1 gallon mayo jars of the 4831 and I still have about half a jar left, still shoots as good as new.
Tom
Forum: Military Rifles
Any chance the dies could be for a different 8x50 case like a Lebel? Also if it would help I would be happy to send you a few pieces of my formed brass to compare.
Forum: Military Rifles
I have one rifle in this chambering and made my brass out of PPU with no issues. The necks were a little long but I found they chambered fine. I would suggest coating one of your cases with a black...
Forum: Black Powder Cartridge
I use 45-90 in my 43 Mausers which is a very similar cartridge. I used dental rubber bands on the base of the cartridge for the first firing. They expanded out and were well centered. After that I...
Forum: Military Rifles
323044
I shot a few rounds through the new to me 1909 Argentine. The 12 grains of RedDot and a 314299PB shoot pretty good. On this rifle the lowest sight setting was 200 meters and they are still...
Forum: Military Rifles
322923322924
I picked up a 1909 Argentine carbine yesterday. A quick clean up and it has a great looking bore so hopefully its as good a cast 314299 shooter as my 1891 rifle.
322925
Tom
Forum: Military Rifles
I partially fill the musket cap with 4f then glue it to a card stock disk, then push it into the tube "backwards." I also set up a set of aluminum round stock bored out for a tight fit on the...
Forum: Military Rifles
Mine is still in the original Chassepot needle configuration. Replaced the rubber obturator with one made from a hardware store rubber stopper and formed on a lathe. It works great and has a couple...
Forum: Military Rifles
322315
Finally got a bayonet for the 1866 Chassepot needle rifle. My grandson is pretty excited to go shoot a few rounds with bayonet attached.
Forum: Single Shot Guns
[ATTACH=CONFIG]321760[/ATT
The lee 450 grain bullet is a pretty close copy of the original, It shoots well in my Springfield 1868 Rifle and 1868 Cadet.
Forum: Black Powder Cartridge
https://hodgdonpowderco.com/wp-content/uploads/2023/04/cowboy-action1-1.pdf
Page 3 has 45-70 load data for their Triple 7.
I use BP, and I also like Triple 7 as well. It has a little more...
Forum: Military Rifles
I have several Mausers including the Portuguese and quite a bit of the Turk ammo. It is pretty hot ammo, I never had a problem with it however in my older age I have since pulled the bullets, dumped...
It started out to be a PIA to install as one leg of the python spring is shorter, its like you need 3 or 4 hands to make it work. I eventually lashed it in place with some dental floss, got the...
I size .454 for mine as that's what the cylinder throats measure.
My double action pull was extremely heavy so I replaced the hammer spring with a python spring from Jack First, now I have a poor...
Forum: Leverguns
320308
I lucked out and found mine on an online auction site a couple years ago for much less than the going rate. I believe it was unfired (probably couldn't find ammo for it), it had a little...
Forum: Gas Checks
As mentioned annealing the copper checks will often help, also maybe a different brand of check (I really like the ones from Sage). I have a simple method that seems to work well for getting them...
Forum: Military Rifles
I shoot a short 95 in 8X56 and the long rifle in 8X50. Both like the lee Bullet, with 2400 in the 8X56 and Herco in 8X50. I have also had good success running .338 jacketed with a little case lube...
Forum: Black Powder Cartridge
For real black powder (not substitutes) you can use either or weight vs volume. For consistency stay with the same system for records and your loading process (you can most likely be more consistent...
Forum: Black Powder Cartridge
I use nickel cases in 45-70 and 45 Colt to I.D. my BP cases. I just treat them as any other BP case, give them a good wash and they are good to go. I have a large mouth gallon jug I fill with water...
Forum: Leverguns
Just remembered the Lyman 47th edition has a write up on all the 1876 calibers (except 50-95).
Forum: Leverguns
https://www.cascity.com/forumhall/index.php?topic=52208.0
CAScity has a section devoted to the 1876, and separate sections for loading each caliber.
...
Forum: Gunsmithing Tips & Tricks
If you cast a lot of odd calibers it might be worth looking at the NOE push through die with interchangeable sizers.
...
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |