So today after a long day I came home pleasantly surprised that the hammer mold came in early. Also when I opened it up it has all the sizes of hollowpoint pin and an additional set of what I think is penta points which I never used before. They are in the middle between the deep hp and the medium one.
I made some up today in penta, deep hp, and the cup point. Powdercoated 1 coat,sized and loaded some up with starting loads.
Does anyone think the cup point will expand some and possibly still pass through on deer?
I think the max load il use with 165grn bullet is around
16 grains of h110 if the accuracy is there and if the cases dont get too sticky in the cylinder. That should push it to between 1200-1300ish fps I think
Lymans most accurate load for 170grn bullets is 14-15 grains of h110 so I hope it will work well.
https://uploads.tapatalk-cdn.com/202...f8bd6a4df7.jpg
Sent from my SM-J337VPP using Tapatalk