Originally Posted by
Green Frog
I’ve been reading this thread with a great deal of interest. From the start it appears that you have happened onto a really useful lathe. I wouldn’t hesitate to add an AXA tool post setup ASAP, especially if you have to get a tool post anyway. There’s a lot of snobbery out there involving “real” Aloris vs the imitators... I “inherited” a bunch of Aloris holders but bought a knock off post, and what I’ve used it, I have no complaints. I would also agree with whoever suggested a set of collets. Good 5C collets are widely available and you should easily be able to find the adaptor to use them in that big spindle. My Sheldon takes 4C and I had the Devil’s own time finding and affording that set!
Anyway, congratulations on your fine acquisition. It sounds like you really “struck gold!” :mrgreen:
Froggie
PS I’ve been told it’s better to get a wedge rather than a piston type mechanism, especially if you buy the cheaper one... perhaps somebody with more experience than I have can comment??