Mixed some PBTP Orange Brown and Smoke’s White Aluminum.
http://i.imgur.com/uLVl17cl.png
Printable View
Mixed some PBTP Orange Brown and Smoke’s White Aluminum.
http://i.imgur.com/uLVl17cl.png
Nice! Who make powder coating? Shake-n-bake or static gun?
These were done with shake-n-bake with the Orange Brown coming from Powder Buy The Pound, and the White Aluminum from Smoke4320.
Are you aware there are different polymer bases? Mixing unlike bases can change the properties of the polymer. When I spray I sweep up the mixed powder to use on things like bullet storage cans, but not for my bullets.
Thanks for that. I wondered about it but could not find any direct info. I did see where folks were mixing brands here. I know they are both TGIC polymer. Don’t know the composition of either. Will be doing smash test before firing. First look is they are as hard as my original test PC boolits. Plan on monitoring shots to begin with.Quote:
Originally Posted by Dragonheart
My main purpose was to mix these two exact colors. If they don’t match up, they’ll see the pot again.
as long as they are both TGIC and you cured properly there should be no issues :)
Mixing a little of Smokes White Alum with any of his dark colors I find gives great coverage and a pleasant "pearl" effect.
Thanks Smoke.
As you were sold out of RAL 8023, had to try this.
I use your method for shake-n-bake.
Yessir! Great way to put it!Quote:
Originally Posted by remy3424
Smash test was GTG!
sounds like you are all good to go
Thank you sir!Quote:
Originally Posted by Smoke4320