What’s the outside diameter of the Lee Case Feeder tubes?
Hoping they are 5/8” (0.625”) to use on my RCBS green machine.
Checking before I order those or bulk polycarbonate tube
Printable View
What’s the outside diameter of the Lee Case Feeder tubes?
Hoping they are 5/8” (0.625”) to use on my RCBS green machine.
Checking before I order those or bulk polycarbonate tube
Lee Case Feeder tubes apr 9/16 with a tape measure, or .565
Thanks!
Just use a poor mans calipers, check with an open end wrench by putting the jaws around the tube, whichever size wrench fits around the tube fairly snug is what size it is. Ore use a Crescent wrench and measure the jaws with a ruler.Quote:
Originally Posted by cheese1566
Just go to a hardware store and match up some pex tubing. You wind uppaying about two bucks for 4 foot of it. If by any chance the outside diameter is a little too big you can always sanded down.
1/2” copper and cpvc line are 5/8” od…
But I want clear.
"Perforate" them...Quote:
Originally Posted by cheese1566
and not trying to steal OP's thread but does anyone know how to adapt the smaller tubes to the case feeder turret? I thought you just dropped them into the big tubes but they fall all the way down to the slide...
Greetings,Quote:
Originally Posted by cheese1566
I made two 4 tube case feeder wheels and used Lee tubes & collator for my Green Machine (RCBS are 5 hole wheels #86532).
I wonder if RCBS Pro Chucker 7 case feed tubes would work (part# 20000211)?
Tube outside diameters per manufacturer:
RCBS = .625
Lee = .562
Dillon = .720
Star = .650
Hope this helps,
Wes