revolvers without adjustable sights
I went to the handgun range today and shot 3 handguns that didn't have adjustable sights. I was shooting cast bullets that I reloaded out of a modrn Taurus total titanium 2 inch barrel revolver, and 2 S&W revolvers, one is a Victory model with a 4inch barrel and one looks just like a Victory model but according to the numbers was made after the war. They shot my hand loads horribly. what am I doing wrong? Do the Victory models need a special load developed for each gun or is there a load that shoots well from them listed in pet loads somewhere II need to be following? The little Taurus was closer to point of aim than the other 2 but it was far from perfect.
S&W 38 spec J frame load.
Add linotype to the alloy. Hard bullets dont skid or slump.
My 5.3 grs of Unique that gives 798 fps, does not group as well or to point of aim.
Both guns like this 700X load.
https://www.thehighroad.org/index.ph...-m60.1356/full
No linotype? Oven heat treat some bullets to harden, as a test. Alloy needs 2% antimony & 2 weeks to fully harden.