PM sent for die.
Printable View
PM sent for die.
PM received and replied to, thanks bw.
lathesmith
CHRIS,
I'm interested in Star dies-- 38/357- Flat point or trunicated cone type 125 or 158 pistol bullet. In sizes - (1) .3575 (2) .358 and also two Locknuts with set screws. My E-mail - grags58@mac.com. method of payment and total cost. Thanks! Gene
Hi Gene, I got your reply, I'll get your stuff going here in a few days.
Thanks,
Chris
Do yo make a .225 die between 60 and 69 grains?
Crawdaddy, I can make a Star die in .225, but you'll have to go to one of the mold vendors to get yourself a good mold for 22.
Thanks,
lathesmith
Sorry, was tired when I wrote that. I wanted a mold.
Hey Chris,
Sent you a check this afternoon for the .331 die!
Thanks,
C
That sounds fine Chris, I'll get you a die going here in a few days.
Thanks,
lathesmith
got my dies today, nobody's lying on this thread, amazing quality and got them quick, Thanks Chris
Chris
Star sizer die arrived and, as always, outstanding quality and super fast turn around. Thanks a bunch!
Jon
Chris,
My wife picked up the die yesterday morning. Thanks!
C
Just to say thanks to Lathesmith. He made me a sizing die, and just like before, I am very happy with the die. I'm a repeat customer, and will buy his products in the future!:drinks:
Chris,
I received my dies today. They look beautiful! You got a customer for life!
CMS
Chris,
I just sent you a PM for a Star Die order (11 flanged dies) a roller handle, top punches,& lock nuts.
Please PM total costs with shipping and payment method.
Thanks,
MOONMAN
Hi Moonman, PM replied to.
Thanks,
lathesmith
PM sent for die.
Just in case everyone gets bored reading the same thing, here it is again.
I ordered a few lock nuts and punches and had them in hand in less than 2 weeks. Personal opinion, but they are every bit as good as the original Stars. I PM'd Chris on this, but neglected to add my .02 worth on the forum.
Stork
I have lone wolf conversion barrels for my Glock 29sf . in 40 S&W and 10 MM. The chambers are substatially smaller on the LW barrels. Currently, reloaded cast bullets in both calibers need to be Swaged down with the dillion Sizer die, without the primer punch. for realiable feeding. I have read so many conflciting view that cast bullet should be larger than the bore or larger than the chamber . that just now I have no clue, what size Star sizer die I need to order from you. Jacketed bullets, being smaller do not cause a problem.
Could I send you a fired case and have you make me a"underszie" die that will not cause a bludge in the case. My idea may not work but seems reasonable. Any suggestions?? I have some as cast bullets if needed
357, how do those rounds that are swaged down with the sizer die shoot? If they shoot OK, maybe you could swage one down, and then pull the bullet and see what size it is after swaging. Since jacketed slugs are (or should be) .400, I would think this would be about what your pulled cast slugs would measure. If you don't have a way of measuring them, you can just send them on to me and I'll handle the rest.
lathesmith