45 ACP Coated Piglet Method
I mixed 1 part powder coat to 3 parts acetone, let the mixture set one week to allow the powder coat to dissolve in the acetone.
Three coats were applied to the bullets, the cooking time had to be extended 5 minutes for the coating to pass the acetone wipe test.
The bullets were sized with a Lee push through sizing die with the powder coat holding up very well.
The surface was a little rough but the areas on the bullet that contacted the sizing die was smoothed out to be very flat and even.
The final third coat was cooked for 30 minutes to make sure the coating was fully cured.
The finished coating passed the acetone wipe test and the smash test.
This coating should work but the surface is still slightly rough.
Coated More 45 ACP today Piglet Method