Cast a few hundred slugs for .45 Colt:
RCBS/NEI 270-SAA (NICE 4 cavity brass molds) roughly 350, and
400 250-RNFP, Lee 6 cavity utility mold.
now the sizing work begins....
Printable View
Cast a few hundred slugs for .45 Colt:
RCBS/NEI 270-SAA (NICE 4 cavity brass molds) roughly 350, and
400 250-RNFP, Lee 6 cavity utility mold.
now the sizing work begins....
I loaded up fifty 45 Colts with that RCBS 270 saa molds bullets ontop of 7.3g Unique.
CW
Hauled my molds,lead pot, gloves etc etc. Out to the patio to do a little casting only to discover all my lead was in storage about 30 miles away. Something for next week.:-(
Unfortunately, I took the afternoon and got my son's 270 sighted in with the scope he got for Christmas so I missed this before I chucked everything in the tumbler. But my loads were pretty good!
(Not really unfortunate with the son and his rifle, man that kid can shoot!!!)
(Obligatory picture of the Stevens attached).
https://uploads.tapatalk-cdn.com/202...32431bb9ee.jpghttps://uploads.tapatalk-cdn.com/202...3cd1c82992.jpg
Sent from my Pixel 5 using Tapatalk
Finally set up my Loadmaster. After setup and a small test run, I knocked out 400 9mm at a rate of 300/hour. A progressive press is definitely the way to go for volume reloading.
I use the tl314 90 swc in my 303 to. using the 308 die to set is smart, I’m going to have to try that.
My load is 5gr Vectan AS and, it will do under an 1.5” at 50m. red dot would probably be a good sub for Vectan AS about same burn rate mine run 1365fps Attachment 27657150m
Searched up all the .224 jwords found 400 to load the rest of my srp then will be out of stock. Will have to reduce load and start using spp, if they will cycle DPMS.Panther.
Put a new shelf up and got my brass mess off the floor.
Sorted thru 38 special fired cases.
Finished seating cores in the derimed 22 lr. Point form tomorrow then clean lanolin off. Back to deriming. Maby I'll go back to .452 from .40 S&W for awhile.
Sorted about 600 38 special and 357 mag cases because some idiot tumbled them together.
Not today, but recently. 1999 9mm primed. https://uploads.tapatalk-cdn.com/202...c4370f5dc0.jpg
Powder coated 300 Accurate 40-180BGs for my 10mm. :D I've still got about 300 more to go from the last casting.
I cast and lubed a couple hundred .356 124gr lrn. had 9mm cases in the vibro tumbler at the same time.
Started processing 1k 223-556 to load last of my srp. Gone load em and seal em and save em.
Started nose forming the 5.56 I words. Will probably finish them. tomorrow. Then who onows?
Cast about a hundred Lee 1oz key drive slugs.
The Night Before, I loaded a hundred rounds of 1oz AA target loads for my friends daughter. She is on the H.S. Trap Club, and I figure if I can cut her practice costs down she can practice more for less...
It's all about the next generation....
Save your moisture absorbent packets from pills and such, you can toss em in the bag after you process em to keep the moisture content down after you run them in the dryer.