You can see the difference in diameter on one of the other one’s I have made, where there is more than enough room for the socket to fit around the nut.
Printable View
You can see the difference in diameter on one of the other one’s I have made, where there is more than enough room for the socket to fit around the nut.
Hi, what material are you printing on?
The abs is giving me problems !!
I'm going to try with Pla, the use of abs is because it's supposed to
It is harder than any other material.
I'm going to try PLA
Thanks, I will comment
Sorry to cause discomfort
thanks for everything.
regards
Diego
I hope so, mate too.
I bought another bullet feeder dock different from the one you use.
The one I bought measures 14mm outside, I do not know what the measurement will be
to which is now.
If you can arrange the file for my combination, I would be very grateful.
regards
Diego
https://www.amazon.es/gp/product/B06...?ie=UTF8&psc=1
I hope this pier serves me .....
It can also be done, it's not too much trouble
I'm pretty handy!: razz:
If they are 15.5 it will be worth it, only there is a difference of 1.5mm:goodpost:
Coming up next:
Hollow base WC collator.
https://www.youtube.com/watch?v=kZ9-5IXuuIY
Thanks to J. DIEGO for printing and testing!
Just wanted to add that you could try PETG. It is easy to print with like PLA but has the strength of ABS. Just read up on what is required to prep your print bed otherwise you could damage your print bed.
I've got half of the parts printed out so far. Hoping to have the rest printed out over the next week or so.
Great job AmmoMike! I am really looking forward to getting this add to my RCBS.
CM
I printed mine in PLA, the one that failed to print (I think the dog got on the table and “played” with it while printing but that’s another story) and even the low fill plate are strong enough to do the job. I could bust an “ear” off the failed body but it would never see that kind of load in use.