I've been working on designing a PCB (circuit board) that the relay could be soldered onto along with terminal blocks for the connection to the switch, Power supply, motor control, sensor and motor. My thinking is this would make connecting everything simpler and eliminate some of the need to solder wires together and reduce the rats nest in the box. It would also allow things like the sensor to be swapped out easily in the event of a component failure.
I had layed it out based on the old schematic. Trying to determine if it is necessary to change it based on the new wiring diagram.
looks like I could get 20 PCB printed in China pretty cheap. Not sure how long they would take to get here though. I may get a batch of them printed when I finalize things and offer a few of the extras here if there is interest.
Here is what it might look like. Dimension are approx 61mm X 47mm
https://uploads.tapatalk-cdn.com/202...26aedb77b9.jpg