I got the chance to set up my new Lee auto drum powder measure. Holly cow where has this thing been! Instead of struggling with running h4895 through the double disk setup I had before and questioning not only if the charge was right but if there even was one, it worked beautifully. Got about 300 rounds of 223 loaded up for my ar.
Setup the other drum for 4.4 grains of bullseye for the 1911. Gonna run out of boolits at this rate and have to cast again. Found out that my Lee pot' s temperature swings pretty wildly and at it's lowest setting is still trying to push 900°, so I'm at an impasse on the casting front. I foresee a PID being added to my casting toolbox.