I found some red satin I can live with.....came in....printed the 9mm feed die with it. Turned out pretty good.....might have liked a darker red, but it pretty......ah Christmassy at least.;)
So I think I'm done with pistol! Yup they all work 100% Very impressed TylerR.
https://i.postimg.cc/h4sy48Qf/IMG-3946.jpg
https://i.postimg.cc/cCFXDZGQ/IMG-3947.jpg
What brand is the red? Overture Satin Red. I'm printing perfect prints now with my Creality for these Feeder Dies with no stringing inside the tubes. Settings on the slicer are as follows:
Bed 65C Nozzle 215C
Retraction Speed 80
Retraction Travel 1.5
Retraction Amount 6
Minimum Retraction .02
Retraction Restart Speed 50
No Z hop
Walls 2
Layer height .12mm
top and bottom solid layers 2 (I may try 3 top layers)
I ran the next smaller drill bit in the tubes....just ran them up and down 3 or 4 times and the inserts slide nice. I did print the 9mm using the "set" .stl to make my Gcode. I still think running them one at a time is even better.....but it takes longer.....this print took 6 hours....Am going to start printing the medium down tube and the #10 spring adapter for this 9mm feeder die next.....they take an hour 40 and an hour 10 in that order......will print them separate to get the smoother cylinders....I mean I don't have to stand there and watch! (I used to when the printer was new....for a while :))
I'm thinking I'm going to ask around looking for some brass to test the 357 sig on my .38 and my 9mm feeder dies. May not find any....not too popular around here.