Ok - so that didnt quite go as planned ... What say ye ...
Attachment 218422
.25 layer height
120 mm/s print speed [ too fast i know ]
215 C - Nozz [ might be a bit too hot for this PLA ] [[ I might try some eSun PLA Pro + also ]]
65 C bed
.5 Nozzle
.55 Line width
8 perimiters
8 top layers
8 bottom layers
Anyone else had an issue at this part of the part ? Looks like a bit of added geometry to the exterior around a few key places might help.
The plastic seems as if it really wants to warp "out" right there.
Part was fine till I gave it a little tug