Originally Posted by
chaoticmachinery
I have a couple of questions as I have someone making this for me.
I seen on one of the posts that the following bronze bushing are needed:
1x Bronze Sleeve Bearing for 1-1/2" Shaft Diameter, 1-3/4" OD, 1" Length
2x Bronze Sleeve Bearing for 1" Shaft Diameter, 1-1/4" OD, 1" Length
1x Bronze Sleeve Bearing for 1/2" Shaft Diameter, 5/8" OD, 1-1/4" Length
So the 1st bronze bearing goes with Page 1 (base plate) per the drawing. Then the 2nd two bronze bearings go Page 3 for the guide rods, correct?
Where does the last bronze bearing go?
Also, I would like to do some reloading on this press. Is there something that I can screw into the ram to take a shell holder? I have a bunch of lee shell holders. Also, I am looking at doing 50 BMG & 338 Lupa reloading on this press so any suggestions for what to use as a shell holder would be appreciated.
Thanks,
CM