I have been wanting to use my fathers reloading press (RCBS JR3) as a dedicated sizer. So I flipped the block over so it now work on the downward pull when the press is upside down. I then wanted a way to guide the bullets into a large bin under my table, so I found a 3/4 piece of pvc I had left over from another project (bike rack in the garage) fit snug. So I heated the end up with a torch and made a slide fit into my Lee sizing die. I then did the same down a little to aim the tube where I wanted it. I plan to paint it so it doesn't look as bad, but it works and cost me $0.
Attachment 196079
Attachment 196080