And now to fill the glass!Attachment 217252
Attachment 217253
Attachment 217254
Printable View
And now to fill the glass!Attachment 217252
Attachment 217253
Attachment 217254
In this video all working!
https://www.youtube.com/watch?v=kLLdlNGysfk
Thanks friend
I'm going to look for it, I'll comment that it's gone
Well I've already done the test and it does not work with this dillon switch either!
I'm going to put an infrared in its place, I already have one mounted that way.
I have located this end of the race, it looks good!
https://www.digikey.ca/products/en?keywords=480-2395-nd
Technical data;
The V7 switch is available as a pin plunger style or with optional integral or auxiliary levers to actuate the switch and
offer versatility in the application. The switch requires as little as 0,15 Newtons [approximately ½ ounce] to operate
for extremely sensitive applications or an operating force of almost 4 Newtons [14 ounces] where higher forces are
required. The V7 switch can reliably control logic level electrical loads from less than 0.1 A to power duty switching up
to 25 A. Agency certifications for the MICRO SWITCH™ V7 switches are provided through CSA, ENEC, and UL for
global use around the world.
Got home from work this morning and my new tall collator was done!! :drinks: Got it installed and running in no time. I didn't have to drill out any of the holes this time. One slight problem, the plug for the drop hole is not the right size. I put some tape around it and it's good enough.
Thanks again Mike!
Attachment 217328 Attachment 217329
I used these switches https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1
I did drill out the rivet, open up the switch and tweak the spring to make it lighter.
Mike here is a video of it working with HB 100 gn RN.
https://www.youtube.com/watch?v=k2uG...ature=youtu.be
Thanks for all the hard work.