Originally Posted by
35 Whelen
Thanks Bulldogger. I like the top design very much.
Without some sort of something to close the capsule and keep the shot therein, seems to me a fella could charge the case, seat an over-powder wad or gas check, fill the capsule with shot, invert the case and insert the capsule, hand seating it and the shot load against the over-powder wad, then give it some sort of light crimp.
Length of capsule- That's a tough one, but I'd think that in order to get the most out of the diminutive .32 Long case the capsule would need to protrude from the case at the very least as much as a bullet (.36") preferably more. I'm thinking a minimum 1" long capsule would work, but I'll take some measurements when I get home.
Diameter of capsule- Since it appears the capsule would need to be hand seated, I'm thinking it would need to be a tad smaller than the mouth of a case after it has been sized. .306" or maybe .307". Again, some measurements are in order.
By "print" I assume you mean a doc with measurements?
Thanks again for doing this.
35W