Originally Posted by
manleyjt
OK I may have started some of this mud slinging. The slinging is **** any way you look at it, it should stop.
I offered once fired LC brass and the swede loaner mould both out of interest in the subject and the testing at hand.
The brass was offered as I know it is what is being talked about for reforming. Larry has told us he has done the case reform with the type of brass beign called out in the instructions. Enough on the brass not being right.
Also on the filler question, how the hell is one to know what is to be used until it was called out. I would not have known which brand and which type to use, but I do now.
As far as the use a true swede, I think the original thread many moons ago that I was part of was actually started by a member with a commercial 6.5x55 rifle not a milsurp. I bit back then and bought a swede96 rifle and a group buy mould to aid in the learning. I learned alot, but not of the level to share in this topic of HV with accuracy.
I did the pound slug and sent them off. They were measured and drawn by 45 2.1, I appreciate that. I am still trying to get good results at low velocity and as such I am living vicariously through Larry, Joe, and Bob. And I would like to live the vicarious life to the fullest.
Has that been done in this instance? Do we know where we stand as far as thos dimensions for Larry's rifle?
Stop bickering and let the tester do his tests. I thought he spelled it out pretty well what he did. Deviance from the prescribed method could have been noted without the bickering and it still can. If you see something wrong give him some guidance, not just a slap upside the head.
Man we have almost two pages of posts that are derogatory towards one or another. No wonder the swedes tried to stay neutral, their rifles and cartridges can devide the world all by themselves.