14mm? Measuring what? I've seen 8 and 12 and mines 18mm, but I haven't found your 14 yet. Or are you talking about detecting distance?
Printable View
TylerR the downloads link seems to be broken. It says file not found. Documents link is still working though.
I am considering printing your larger version to use as a case feeder for my new Lee APP. Been using it with my GolluB case feeder by setting the Lee App up next to my Dillon. But I think it needs it’s own case feeder. So I wanted to take a look at your files to figure out what to print. Thanks.
1st Piece a little stringing... But I haven't used this Filament in a year.....
Amazon Basic PLA... I had to de-humidify it as it was very brittle.... I will be using a new roll when I print anything big
Attachment 273502
Finally got the long (extra large) spring in and definitely a higher quality spring. But now I'm so unsure of how long I want it to be and where to cut it :O
My case feeder is almost done and will collated .223 and .308 perfectly, but the .223 required one more little part....an extension to lower the proximity sensor a little. Seems the .223's stopped fine but since the cases are small it allowed one too many in the stack and raised the stack into the turning plate a quarter inch. Lowering the switch a little fixed it, so now it collates both equally well with no other parts change except for the .308 specific and .223 specific turning plates.
Tomorrow morning I will start the 2 hours extension print.....then once done, I will post a couple of running vids of the collator working those two calibers. Finally!
This link will get you there
https://drive.google.com/drive/folde...y0qvUSP9B4MwvV
Sensor says it is out for delivery. We will soon know how well it works.
So I have been reading through this thread and am impressed with the thoroughness. One question I have though, and it may be covered somewhere in the 150 pages, is what is the “minimum” level of 3D printer recommended to accomplish this. I see several references to $200 printers, but the ones I see are all pretty small at that price point. If I’m a 3D printing noob, is there a recommendation for a printer?
Anyone else with Filament types before I send the file to Tyler?
Perfect I will do that a little later.
Thanks for putting the larger wallextender in the dropbox. Much appreciated :) I will print it soon and post a pic.