Originally Posted by
curioushooter
Still three steps instead of one.
I take a raw casting, place it in my Lube-a-Matic II, pull the handle, twist the screw (sometimes), and out comes a sized, lubed, and checked (if such a design) bullet.
If PC is anything like TL (tumble-lubing) it needs to re-done after sizing. If anything PC is worse because the layer is much thicker.
Another thing that I don't like about PC is that it anneals the bullet. After getting your alloy at the correct hardness now you are going to soften it in an oven?
Also, what about gas checks?