1870/78/15 Italian vetterli Load

So I picked one up off GB about 2-3 months ago and haven’t loaded anything for it yet. Since these rifles were originally black powder and then during WW1 had a barrel sleeve installed to convert them to 6.5 carcano.

I don’t know where a safe starting point for this rifle would be at and I’ve heard a ton of stories of people putting factory loads in them and blowing them up.

If anyone has any experience or advice on where I should even start with this load I would appreciate it.


Sent from my iPhone using Tapatalk

Does yours have the 6.5 Carcano sleeve installed?

Quote:

---

Originally Posted by Bakebfr480

Does yours have the 6.5 Carcano sleeve installed?

---

Yes


Sent from my iPhone using Tapatalk

What I read years ago was that the 6.5 conversion was marginal with full military loads but was intended for secondary troops and therefore not likely to get much use. You may need to stick to starting level loads for safety.

I have one with a very good bore that is an outstanding shooter. With 6 grains of Trailboss and a .270 diameter cast bullet of 140 grains 1/2" 5 shot groups at 50 yards have been gotten. I have a target with same load of 4 shots at 50 yards into one ragged hole. I made a full length scope and mounts for the rifle that is about 6 power and that is why I`ve shot such groups.

Did you watch this video? Good to have your rifle checked before firing, not just because of full power loads, but because it may have damage otherwise:
https://youtu.be/-qOEh_DwJR0?t=1

Quote:

---

Originally Posted by Paul in Oregon

I have one with a very good bore that is an outstanding shooter. With 6 grains of Trailboss and a .270 diameter cast bullet of 140 grains 1/2" 5 shot groups at 50 yards have been gotten. I have a target with same load of 4 shots at 50 yards into one ragged hole. I made a full length scope and mounts for the rifle that is about 6 power and that is why I`ve shot such groups.

---

Thanks good to know!


Sent from my iPhone using Tapatalk

Quote:

---

Originally Posted by fgd135

Did you watch this video? Good to have your rifle checked before firing, not just because of full power loads, but because it may have damage otherwise:
https://youtu.be/-qOEh_DwJR0?t=1

---

Yes I’ve watched it quite a few times actually lol, I plan on doing a detail cleaning and safety check of it probably today, everything on it seems to function just fine otherwise.


Sent from my iPhone using Tapatalk

Quote:

---

Originally Posted by Bigmancrisler

Yes I’ve watched it quite a few times actually lol, I plan on doing a detail cleaning and safety check of it probably today, everything on it seems to function just fine otherwise.

---

Excellent! If it doesn't work out to shoot that rifle, it's tall enough to convert to a floor lamp for the gun room!

Quote:

---

Originally Posted by fgd135

Excellent! If it doesn't work out to shoot that rifle, it's tall enough to convert to a floor lamp for the gun room!

---

Hahaha ya, it would certainly be a cool wall hanger but no one is here for just walk hangers [emoji6]


Sent from my iPhone using Tapatalk

I’ll let y’all know how it goes once I actually get around to cleaning it and everything.


Sent from my iPhone using Tapatalk