You would think these little hand deburring tools would be a simple little deal and any and all of them would put a smile on your face.
Yesterday I was trimming some 45 colt brass, and my deburring tool is good from 17 to 45 cal. It works and works great, but on the 45 cal it barely is big enough for outside deburring, making you really pay attention to getting it on the case right. I went and bought one that is good from 17 to 60 cal, making thinking it would be great and faster for the 45 brass. this is rcbs and it works like I thought it would, except as far as I'm concerned it is junk. It leaves a rough edge on the brass. My old one has been around for a long time and even though it is barely big enough to use on the 45 brass, I had to use it to finish after using the new one, so just went back to using it instead.
The old one is made for rcbs by wilson, the new one just says rcbs on it, it doesn't say on the tool, but this morning out of curiosity I dug the package out of the trash, and it is made in china.
Maybe I'm too picky, but you would think that china could at least get something as simple as this right. I would also think that something as simple as this, is that rcbs could find some company in the us to make a quality tool, and still be in the price range ballpark.