1 Attachment(s)
2 part epoxy on 9mm cast bullets, got some done.
I have been working my tail off trying to figure out this 2 part epoxy on these 9mm 125 grain. Looks like its going to work. only question I have is should I bake them also? after they are dry they are rock hard so I really don't see baking would help, but I really don't know? I mixed this 2 part epoxy, and used a small air brush to paint the coat on lightly. This paint is so good I threw a few into the molting lead pot, and watched them literally take 1 minute longer to melt than compared to regular lead I was throwing in there. Following I took some conuba wax, and applied a thin coat. I tried to dip the bullets, but it the paint was too thick applying it like that. Also tried the shake in a cup method, but paint did not cover all areas of the bullet before getting tacky.
Thanks for looking, and its hotter than a fire cracker down here in Texas,,,,, cant wait for winter! lol:lovebooli
